[Sep 21, 2023] Get New DEA-5TT2 Practice Test Questions Answers
DEA-5TT2 Dumps and Exam Test Engine
NEW QUESTION # 18
Which IEEE standard defines the Data Link Layer, Discovery protocol?
- A. 802.1AB
- B. 802.1AX
- C. 802.1D
- D. 802.1W
Answer: A
NEW QUESTION # 19
Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?
- A. N1500 Series switch and N2000 Series switch
- B. N1700 Series switch and N3500 Series switch
- C. N1700 Series switch and N1500 Series switch
- D. N3500 Series switch and N2000 Series switch
Answer: A
NEW QUESTION # 20
Which type of domains are connected by a Layer 2 switch?
- A. Multiple collision domains and a single broadcast domain
- B. Multiple broadcast domains and multiple collision domains
- C. Single collision domain and a single broadcast domain
- D. Single collision domain and multiple broadcast domains
Answer: A
NEW QUESTION # 21
How is a switch different from a hub?
- A. A switch tracks MAC addresses of all connected devices.
- B. A switch does not include any latency into the frame transfer time.
- C. A switch operates at a lower, more efficient layer of the OSI model.
- D. A switch decreases the number of broadcast storms.
Answer: A
NEW QUESTION # 22
Which port and protocol is used by NTP to communicate?
- A. TCP port 123 for both the source and destination
- B. UDP port 123 for both the source and destination
- C. UDP port 123 for the source and TCP port 80 for the destination
- D. TCP port 123 for the source and TCP port 80 for the destination
Answer: B
NEW QUESTION # 23
When configuring a switch, which CLI mode only supports limited show commands?
- A. EXEC Privilege
- B. EXEC
- C. Maintenance
- D. Configuration
Answer: B
NEW QUESTION # 24
Which BASE-T Ethernet standard specifies a CAT6 cable type?
- A. 10BASE-T
- B. 10GBASE-T
- C. 2.5GBASE-T
- D. 5GBASE-T
Answer: B
NEW QUESTION # 25
What accurately describes OSPF?
- A. Exterior gateway distance-vector protocol
- B. Interior gateway distance-vector protocol
- C. Interior gateway link-state protocol
- D. Interior gateway path-vector protocol
Answer: C
NEW QUESTION # 26
What are Network Address Translation (NAT) inside global addresses?
- A. Public IP addresses used by the local network to communicate with the Internet
- B. Addresses used by NAT router when sending frames to devices on the local network
- C. Private IP addresses used by the local network
- D. Pubic addresses used by other networks outside of the local network
Answer: A
NEW QUESTION # 27
Which route type is added to the routing table by a routing protocol?
- A. Default route
- B. Directly connected
- C. Static
- D. Dynamic
Answer: D
NEW QUESTION # 28
A network administrator has a stack of four Dell EMC Networking S4800 Series switches. Each stack unit is configured with a different priority. Which switch will be elected as the management device?
- A. Switch with priority 0
- B. Switch with priority 1
- C. Switch with priority 21
- D. Switch with priority 14
Answer: B
NEW QUESTION # 29
Which IP address is in the Class B range?
- A. 192.15.48.130
- B. 126.16.20.48
- C. 191.56.44.200
- D. 100.100.90.87
Answer: C
NEW QUESTION # 30
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 31
On which OSI layers do standard ACL filters operate?
- A. 3 and 4
- B. 2 and 7
- C. 4 and 7
- D. 2 and 3
Answer: A
NEW QUESTION # 32
What are the Protocol Data Units (PDUs) called at the Transport layer?
- A. Frame
- B. Segment
- C. Packets
- D. Data Payload
Answer: B
NEW QUESTION # 33
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?
- A. ff02::/8
- B. fe08::/64
- C. fe80::/64
- D. fd01::/64
Answer: C
NEW QUESTION # 34
Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?
- A. Inside source static
- B. Outside source static
- C. PAT
- D. Overload
Answer: A
NEW QUESTION # 35
Which formula is used for calculating OSPF interface costs?
- A. Interface bandwidth / reference bandwidth
- B. Reference bandwidth + interface bandwidth
- C. Reference bandwidth / interface bandwidth
- D. Reference bandwidth - interface bandwidth
Answer: A
NEW QUESTION # 36
In IPv4, what is the proper conversion from binary to decimal for the number 11010010?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION # 37
Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is visible on Router A?
- A. 144.254.0.0/16
- B. 144.254.32.0/24
- C. 144.254.0.0/24
- D. 144.254.32.2/24
Answer: B
NEW QUESTION # 38
Which flags are used in the TCP header to initiate and end TCP connections or sessions?
- A. Initiate = Finish (FIN) End = Synchronize (SYN)
- B. Initiate = Acknowledge (ACK) End = Finish (FIN)
- C. Initiate = Synchronize (SYN) End = Finish (FIN)
- D. Initiate = Acknowledge (ACK) End = Synchronize (SYN)
Answer: C
NEW QUESTION # 39
On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?
- A. Autonomous System Boundary Router (ASBR)
- B. Area Border Router (ABR)
- C. Backbone Router (BR)
- D. Designated router (DR)
Answer: A
NEW QUESTION # 40
......
EMC DEA-5TT2 (Associate - Networking) Certification Exam covers a range of networking topics, including network design, network protocols, network security, and network troubleshooting. It is a comprehensive exam that tests individuals on their ability to design, deploy, and manage EMC networking solutions. DEA-5TT2 exam consists of multiple-choice questions and is designed to be challenging and rigorous.
2023 New ITCertMagic DEA-5TT2 PDF Recently Updated Questions: https://www.itcertmagic.com/EMC/real-DEA-5TT2-exam-prep-dumps.html
EMC DEA-5TT2 DUMPS WITH REAL EXAM QUESTIONS: https://drive.google.com/open?id=1NN454WQ8khh2EfReR46IA1Eb5I7IHuS8