Use Real NACE Achieve the NACE-CIP2-001 Dumps - 100% Exam Passing Guarantee
Verified NACE-CIP2-001 Q&As - Pass Guarantee NACE-CIP2-001 Exam Dumps
NEW QUESTION # 22
Coating Surveys are legally required:
- A. On high pressure gas lines and fireproofed structures
- B. On commercial marine vessels and offshore platforms
- C. On water tanks and potable water pipelines
- D. On food and beverage vessels and can linings
Answer: B
NEW QUESTION # 23
The Concrete Repair Institute's comparators can be used to assess:
- A. Surface cleanliness prior to coating
- B. Surface profile prior to coating
- C. Compressive and tensile strength prior to coating
- D. Contamination levels prior to coating
Answer: B
NEW QUESTION # 24
When completing the Final Inspection report the Inspector should write the report using:
- A. Language that another NACE Inspector would understand
- B. Language that the most would understand
- C. Language that only in the project would understand
- D. Language that only technical experts would understand
Answer: B
NEW QUESTION # 25
The number of air turns in an enclosure can be affected by all of these EXCEPT
- A. time of the year (winter/summer).
- B. manufacturer of the equipment.
- C. coating type.
- D. type of dehumidification equipment (refrigerant or desiccant).
Answer: C
NEW QUESTION # 26
Dehumidification is defined as the removal of moisture vapor from the air to
- A. lower its temperature
- B. provide worker comfort.
- C. raise its relative humidity.
- D. lower its dew point,
Answer: D
NEW QUESTION # 27
When ASIN D 3363 is specified the Inspector must:
- A. Record the highest value attained
- B. Use the correct solvent
- C. Record the two end points identified in the standard
- D. Record the percentage of failure
Answer: C
NEW QUESTION # 28
Surface preparation of concrete is performed using:
- A. Methods that are exactly the same as steel
- B. Methods that are the same as wood
- C. Methods that have been modified for concrete
- D. Methods that are completely different to steel
Answer: C
NEW QUESTION # 29
External coatings applied to buried pipelines are generally tested for:
- A. Cathodic disbondment
- B. Chalking resistance
- C. Gloss level
- D. Solvent resistance
Answer: A
NEW QUESTION # 30
It is always possible to see moisture on a steel substrate:
- A. True
- B. False
Answer: B
NEW QUESTION # 31
Inspectors perform tests on linings that they may not perform on exterior coatings because
- A. linings are more durable than coatings.
- B. coatings are more durable than linings.
- C. coatings are expected to degrade over time.
- D. linings protect the contents and the container.
Answer: D
NEW QUESTION # 32
When observing fabrication defects the NACE Inspector should:
- A. Require they be corrected prior to coating
- B. Consult the specification to determine how they should be treated
- C. Write an NCR and call the fabricator
- D. Stop the job immediately
Answer: B
NEW QUESTION # 33
Generally for safety considerations, waterjetting hose connections use
- A. a whip-lock device.
- B. an oil/water separator.
- C. filters.
- D. a long wand.
Answer: A
NEW QUESTION # 34
Which is used to calibrate a pH meter?
- A. Distilled water
- B. Deionized water
- C. Standard solvent solution
- D. Standard buffer solution
Answer: D
NEW QUESTION # 35
You are the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no individual gauge reading shall be below a certain value.
As this is not part of the standard you should:
- A. Call your supervisor
- B. Ignore the additional requirement
- C. Enforce the additional requirement
- D. Request clarification from the specifier
Answer: C
NEW QUESTION # 36
You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:
- A. Correct the errors yourself and suggest the Level 1 inspector be replaced
- B. Correct the errors yourself and advise your supervisor that the Level 1 Inspector is incompetent
- C. Have the Level 1 Inspector correct the errors and set up remedial training to improve the quality of documentation
- D. Correct the errors yourself and submit the reports without any further action
Answer: C
NEW QUESTION # 37
A single component water borne acrylic coating cures by:
- A. Solvent Evaporation
- B. Coalescence
- C. Co-Reaction
- D. Oxidation
Answer: B
NEW QUESTION # 38
......
Check the Free demo of our NACE-CIP2-001 Exam Dumps with 100 Questions: https://www.itcertmagic.com/NACE/real-NACE-CIP2-001-exam-prep-dumps.html
Clear your concepts with NACE-CIP2-001 Questions Before Attempting Real exam: https://drive.google.com/open?id=1n8Arz2pVWBz3kxv5Y82Xo3h7Vw1LYhg3