Use the best ways of preparing for HPE6-A66 Exam Dumps with ITCertMagic HP HPE6-A66 dump PDF [2021]
HP HPE6-A66 exam candidates will surely pass the Exam if they consider the HPE6-A66 dumps learning material presented by ITCertMagic.
NEW QUESTION 30
Which AP mode allows an AP to operate autonomously?
- A. AM
- B. IAP
- C. RAP
- D. OCAP
Answer: D
NEW QUESTION 31
A customer is designing a new wired network. The customer requires 50 Gbps uplinks, VSF logical switching, and smart rate port support Which of the following switches would meet these requirements?
- A. 5400R series
- B. 3810M series
- C. 8300 series
- D. 6300 series
Answer: B
NEW QUESTION 32
A network architect is creating a new wireless solution for a customer. Wireless coverage is required throughout all four floors of two buildings on the same campus. Dynamic RF capabilities, including AirMatch, are required. Seamless roaming is required within and between the two buildings. Each floor will have approximately 20 APs and 6 external APs are required for connectivity between the two buildings.
- A. A standalone 7008 controller per floor
- B. Two 7205 mobility controllers in a cluster
- C. Given this information, which Aruba solution would be the most cost-effective while still meeting the customer's requirements? O An IAP cluster per floor
- D. Two 7030 mobility controllers in a cluster
Answer: C
NEW QUESTION 33
A customer placed an order for an ArubaOS 5406R switch and plans to rack mount it in a wiring closet. The dimensions of the switch are 17.5 inches wide (44.45 cm), 6.9 inches high (17.5 cm), and 17.75 inches deep (45.1 cm). How many rack units should a customer plan for this switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 34
A customer has some employees that travel to various locations, where these employees will need Wi-Fi access at these locations. Because many of these locations do not have wireless support, the employees will need to carry an AP solution with them. Internet connectivity, if it doesn't exist at these locations, will be provided by a national phone company USB wireless card which will be connected to AP. The wireless solution needs minimal bandwidth, but needs to minimally support 802.1 lac wave 1 devices.
Which Aruba AP wireless solution would meet the needs of these employees most effectively and cost efficiently?
- A. 0
- B. 203R
- C. 1
- D. 303H
Answer: B
NEW QUESTION 35
A customer has a need to track traffic patterns and anomalies on a pair of ArubaOS-CX 8400 series switches. Which technology will the customer need to deploy for these switches?
- A. Network Analysis Engine
- B. Mobility First
- C. 2 CiearPass
- D. NetEdit
Answer: D
NEW QUESTION 36
A network architect is designing a new Wi-Fi solution for a small university The solution will involve two mobility controllers that will be clustered at the campus core Because students use a lot of video in both the dormitory rooms and in the classrooms, the solution will need to support 50Gbps via link aggregation between the controllers and core switches.
Which solution would most cost-effectively meet this requirement for the campus core?
- A. Aruba 7280 mobility controllers and 5406R switches
- B. Aruba 7220 mobility controllers and 3810M switches
- C. Aruba 7210 mobility controllers and 5406R switches
- D. Aruba 7240XM mobility controllers and 3810M switches
Answer: B
NEW QUESTION 37
A company has hired a network architect to replace an existing legacy wireless and wired network The building is one-story and contains four wiring closets Based on the information the network architect gathered from the company, one 48-port POE+ switch and three 48-port non-POE+ switches will be placed in each wiring closet. One stacking domain should be created for each wiring closet that supports 40 Gbps uplinks.
Which stacking solution should the architect implement for the floor that meets the requirements and is the most cost-effective'?
- A. VSX
- B. Distributed trunking
- C. Backplane stacking
- D. VSF
Answer: A
NEW QUESTION 38
A network architect is given the task to design a new network solution for NewStellar Company, Inc. NewSteiiar has a main corporate campus in a business park with two adjacent buildings. The network architect has given one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.
Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total, which results in a total of 338,100 feet (31,410 square meters) for the entire building space. Each floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet {870 square meters).
Because of security concerns, video cameras will be installed throughout the facility. There are 16 of these per floor, 8 per wiring closet. The cameras are non-WiFi capable and require POE 802.3af-capable switch ports from which to draw power.
A wireless capacity design is required. Assuming that wireless coverage is required across the Building 1, Floor 2, including the central area, and that half the required APs will connect to each wiring closet, approximately how many POE+ ports will be required per wiring closet for all devices that have POE or POE+ needs?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 39
A customer is purchasing Aruba 555 APs for a new wireless network. The APs will be pre-staged as campus APs (CAPs) and be managed by a controller solution During the pre-staging process, console access to the APs might be necessary Which console connection cable should the customer purchase for the 555 APs?
- A. Micro-B USB
- B. RS-232
- C. RJ-45
- D. USB-A
Answer: A
NEW QUESTION 40
Which must you perform in IRIS to assign a device to a Design Group?
- A. Right-click the device and select Set Design Group
- B. Drag and drop the device into the Site
- C. Drag and drop the device into the Design Group
- D. Right-click the device and select Set Layer Membership
Answer: C
NEW QUESTION 41
A customer requires Aruba switches that support Smart Rate ports to connect to Aruba APs Which switching product should the customer purchase that will provide 24 Smart Rate ports per access layer switch'?
- A. Aruba 2930F
- B. Aruba 2540
- C. Aruba 2930M
- D. OfficeConnect 1950
Answer: C
NEW QUESTION 42
A network architect has developed a design for a new Aruba Wi-Fi network that will include a hardware Mobility Master (MM) running the ArubaOS 8 4 operating system that will manage:
* Two clustered 7205 controllers with 300 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
The architect plans on creating user roles, firewall policies, and wireless IPS policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-500. LIC-MC-VA-50 (X2), LIC-AP <x375). PEF (x375). RFP (x375)
- B. LIC-MC-VA-50 (X2), LIC-AP (375), PEF (X375), RFP (X375)
- C. LIC-MC-VA-50 (x1), LIC-AP (300), PEF (X300). RFP (x300)
- D. LIC-MM-VA-50, LIC-MC-VA-50 (X1), LIC-AP (X300), PEF <x300). RFP (x300)
Answer: D
NEW QUESTION 43
Which type of Aruba AP uses its radio as its back-haul connection?
- A. Remote AP (RAP)
- B. Air Monitor (AM)
- C. Mesh Porta
- D. Mesh Point
Answer: C
NEW QUESTION 44
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Paint the APs to match the ceilings or walls
- B. Place a strip of tape over the LEDs
- C. Order Aruba AP covers for the APs
- D. Place the APs above the ceiling and behind the walls
Answer: D
NEW QUESTION 45
A network architect plans to use two ArubaOS 5406 switches in a wiring closet configured in a VSF domain The VSF link requires a 40 GDps connection Which SFP+ transceiver solutions would meet this requirement?
- A. QSFP28
- B. SFP
- C. SmartRate
- D. QSFP+ LC
Answer: C
NEW QUESTION 46
A network architect needs to design a new wireless solution for a small company The architect estimates that about 150 APs will be required to implement a capacity design. Roaming support is required. Also, the design requires meshing to connect some of the APs to the network.
The customer requires that client state synchronization be provided for real-time failover.
Which solution would most cost-effectively meet these requirements?
- A. Two 7205 mobility controller and campus APs in a cluster
- B. lAPs in a cluster
- C. FRAPs in a cluster
- D. Two 7030 mobility controller and campus APs in a cluster
Answer: C
NEW QUESTION 47
A company has two buildings on a campus, where each building has three floors, which two wiring closets per floor Assume that there will be 24 APs connected via POE+ to each wiring closet, along with 128 wired user connections. Which backplane stacking solution will provide the necessary Ethernet port capacity for all devices on Building 1 Floor 2 and is fully meshed?
- A. One 2930M 24-port POE+ switch and two 2930M 48-port switches per wiring closet
- B. One 381 OM 24-port POE+ switches and two 2930M 48-port switches per wiring closet
- C. Two 381 OM 24-port POE+ switches and three 381OM 48-port switches per wiring closet
- D. Two 2930F 24-port POE+ switches and three 2930F 48-port switches per wiring closet
Answer: A
NEW QUESTION 48
......
Full HPE6-A66 Practice Test and 60 unique questions with explanations waiting just for you, get it now: https://drive.google.com/open?id=1tMnazVYMCgukX0XoqZvqVreAg9Kcra9B
Accurate & Verified Answers As Seen in the Real Exam here: https://www.itcertmagic.com/HP/real-HPE6-A66-exam-prep-dumps.html